A duct kit is available for the Capri 50-SSC. They require good ventilation, preferably expelling the heated air to another location by attaching a flexible duct of not more than 6' in length to the duct ring on the unit. Veco NA, LLC P O Box 3518 Annapolis MD Rev 13 12/2006 Chapter 1 Frigoboat systems A Frigoboat system consists of the following components: (1) A compressor / condensing unit that is either: Air cooled - Paris 35F or Capri 50-SSC Water cooled - W50F (with pump) Keel cooled - K50-SSC (with keel cooler) (2) An electronic controller connected to and installed on the compressor (3) Either a mechanical thermostat for refrigerator, freezer or holding plate, or a Carel digital thermostat/thermometer (4) A Smart Speed Control (SSC), standard on Capri 50-SSC and K50-SSC systemsĢ (5) An aluminum or stainless steel evaporator plate or holding plate (6) A water pump, for W50F only (7) A keel cooler, standard on K50-SSC, optional with Capri 50-SSC Chapter 2 Paris 35F and Capri 50-SSC Air cooled These units are designed to be mounted on a horizontal surface in areas where they will not be susceptible to physical or water damage, but accessible for service. 1 Frigoboat Marine Refrigeration Systems Installation & Instruction Manual For Models: Paris 35F, Capri 50-SSC, K50-SSC, W50F (Also applicable to any Frigoboat system using Danfoss BD 35 & 50 compressors) It is important to read this manual thoroughly before installing a Frigoboat system.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |